BV26C – CLASSIC

PLATE SIZE 980x750 MM 38x29 inch


BV26C -  FRONTAL VISION

Description and standard equipment

Entry - level version for small and medium-sized moulds

For assembly, adjustment, checking and repair of dies (for thermoplastics, die-casting, thermosetting, rubber and blanking) with the possibility of low pressure injection into the moulds.

Parallelism is completely managed hydraulically by means of a special flow rate cylinder, whereby the system distributes equal oil quantities to the two ascent and descent cylinders.

Construction

Very stable structure with sturdy base made of welded and normalized steel and cast iron base plate.

Upper Plate

The upper plate slides vertically by hydraulic actuation on the four guide columns and can be overturned 360° through reduction gears. In this way, it is possible to place the upper part of the die or mould in an effortless working position. The upper plate clamping in the exact horizontal position depends on the four hydraulic actuated locating pegs.

BV26C - LAYOUT

BV26C - CONTROL PANEL

Video

Accessories

Energy accumulator (single shot)
For the development of moulds for plastics, rubber and die-casting. It is a hydraulic device which is fixed to the upper plate of the press. It gives an instant blow to the closed mould to optimally check the coupling between the two half-moulds (punch and die). The dynamic action of the device is independent of the closing movement of the press. As a result, the dynamic effect of the energy accumulator is added to the closing force of the press. Increases the efficiency of the Prussian blue marking.

Accumulatore di energia (a colpo istantaneo)

Special Wax Automatic Injection Unit
This attachment provides a way to inject special wax at a low pressure into the mould cavity. This makes it possible to check, on the basis of the moulded parts obtained, the dimensions and thicknesses of the degree of tightness of the mould, and any burrs and flashes. The wax injection attachment includes: wax container with thermostat-controlled electric heating, pneumatic drive with air pressure control, and a temperature control for the chamber to attain constant wax fluidity. Dynamic verification of the extractor elements.

Unità automatica d’iniezione di cere speciali

Hydraulic Ejector Unit
Drives the movement of the extraction pins of moulds for plastics and die-casting. Dynamic verification of the elements.

Unità espulsore idraulico

Control Unit Of Auxiliary Cylinders In The Mould
This hydraulic device allows movement of cylinders applied on the die or mould for greater control of mobile parts (max 2+2).

Unità di comando cilindri ausiliari

X

Request Pdf

I read and agree to the disclosure in accordance with Legislative Decree no. 196/2003
verification code

Reg. Imp. Milano 08060920157 REA 1200630 - P. Iva 08060920157 | Millutensil S.r.l ©2016 | CREDITS