The die-splitter is used for splitting, adjusting, maintenance and try-out operations on progressive and transfer dies such as blanking, die casting, etc.
The platens of the die-splitter are provided with 2 large cavities that allow the operator to reach the lower part of the die-half, allowing rapid assembly and disassembly of the various parts of the dies.
The lower plate travels on rails away from the columns for clear and open loading and unloading. At the ends of the rails is a 90 degree tilting option that tilts the lower die section to a vertical position for. An easy access to the front and back. After the die is loaded, the plate returns back to its initial position, mechanically and precisely stops itself, to ensure precision opening and closing of the die halves and repeatability.
As the upper plate slides vertically by hydraulic actuation on the four guide columns and rotates 360 degrees by reduction gears, it is possible to put the upper die half in any work position to carry out the working operations. Clamping of the upper plate in the exact horizontal position is performed using four hydraulically actuated locating pins.
Each button on the control panel is marked with a clear function. The PLC controls the sequence of movements and prevents from operator’s mistake.
Machine control – functions
Tel. +39 02 29404390
Fax +39 02 2046677
Offices and headquarters
Corso Buenos Aires, 92
20124 Milano - Italia
Via delle Industrie,10
26010 Izano (CR) – Italia
Reg. Imp. Milano 08060920157 REA 1200630 - P. Iva 08060920157 | Millutensil S.r.l ©2016 | CREDITS